Clean, Fast & Efficient Combustion: ZoneProtect™
HighSense™:SO₂的高性能UV吸收吸收
The combustion analyzer G4 ICARUS Series 2 with high frequency (HF) induction furnace and HighSense™ detection stes new standards in for a rapid and precise carbon (C) and sulfur (S) analysis in inorganic solids.
由于它们对材料特性的影响,对快速和可靠的CS分析的需求不限于铁和钢,还适用于亚铁和非有产金属,其合金,陶瓷,矿石,水泥,石灰石和许多其他无机固体。
当结果很重要时,虽然必须在第一枪中授予准确性,但在最小的样品准备中,燃烧分析对于光元素的分析是不可替代的。这些很难或不可能通过直接的光谱方法进行测量,尤其是当嵌入困难的矩阵中时。例如。G4 ICARUS系列2即使在灰色铸铁中也提供了准确的曲折,在灰色铸铁中,碳以石墨簇的形式不均匀地分布,因为它采用了体积方法 - 分析整个样品。
规格 | Benefit | |||
Samples |
无机,干,任何形式或形状 |
灵活性 |
||
Typical Samples |
Ferrous and nonferrous metals and their alloys, ores, cement, limestone, glass, ceramics, soils | Wide variety of sample materials | ||
Sample carrier |
Ceramic crucibles (standard form) | Usage of industry standard consumables, lower cost, security of supply | ||
样品重量 |
0.1 - 1 g(典型的0.5 g) | |||
炉 | 高频感应炉,可通过ZoneProtect™调节功率 | 更高效,更快的燃烧效率 | ||
探测器
硫 |
带有参考光束路径的双范围NDIR检测器
|
可靠,无维护的性能而无需漂移 Unique wide range performance with unrivaled signal/noise without drift |
||
Carrier Gas | 氧气99.95%纯度 (微量碳所需的99.995%) 3.5 bar(50 psi)分钟。压力 |
标准气体纯度足够 | ||
Compressed air | 5 bar(72.5 psi)分钟。压力,油,水和无颗粒 | |||
Speed Analysis Time |
40 s(名义) |
Fast, simultaneous analysis | ||
完整的周期时间 |
< 1 min (typical) | High productivity and throughput with waste disposal into crucible | ||
Noise Emission | < 50 db | 享受安静 | ||
Calibration | Single and multipoint calibration with solid standards | |||
试剂 |
|
|||
Power Supply | 230 VAC (± 10 %); L1 N; 50-60 Hz; 16 A; 2.7 kVA 208 VAC (± 10 %); L1 L2; 50-60 Hz; 16 A; 2.7 kVA |
Industry standard power and current configurations | ||
*)根据要求提供基于NDIR的检测器 |
We provide:
Check out oursupport websitefor:
Registration required.